How To Clean A Pump On A Whirlpool Washing Machine

How to clean the pump in the Virpul washing machine With frequent use of the Virpul washing machine, the pump may clog it. If you do not take emergency measures, sooner or later with a pomp more serious problems will begin, and it will generally fail. To avoid this, let's figure out how to clean the drain pump in the washing machine.

How to understand that the problem is in the pump?

If there are problems with the pump, a number of characteristic signs will appear, by which you can easily determine that the pump is malfunctioning. Among them:

buzzing and hissing during draining after washing;
water drains for a very long time with difficulty;
sometimes water does not drain at all if the pump is very clogged.

What caused these "symptoms" in your washing device? We already realized that pump clogging is to blame for everything, but why is it happening? The fact is that the drain path must be cleaned periodically, and if this is not done, all garbage that gets there when washing clothes (hair, dust, threads) or from the drain pipe gradually clogs the pump. Also, some cheap detergents are poorly soluble, and precipitates formed after their use also remain in the tract. This subsequently leads to failures.

Prepare the machine for repair

So, open the instructions and carefully look at where the pump of the Whirlpool washing machine is located, so as not to spend a lot of time searching for it and not damage other details. If you are sure that you figured it out, prepare two types of screwdrivers: a flat and a Phillips screwdriver, as well as an open-end wrench and some kind of flat container. A container is needed so that water from the pump does not spill onto the floor. First of all, disconnect the unit from the mains and water supply for your own safety in order to avoid unforeseen problems.

Before dismantling the pump, clean the filter and drain the remaining water.

Now you can proceed directly to the dismantling. Open the small door on the skirting board of the washer (it is located in front from the bottom). There is a filter. Unscrew it carefully with counterclockwise movements. Depending on the model, the filter can still be secured with an additional bolt. Then unscrew it with a screwdriver!

remove the filter

We clean the pump

The pump is located at the bottom of the machine, one might say, at the bottom. Sometimes the bottom of the machine is not covered by anything, and sometimes manufacturers attach an additional panel there. To get to the pump, you need to remove it. You can also put the machine in a position convenient for you to freely interact with the contents of its lower part.

remove and clean the pump When you saw where the pump is, loosen the pipe clamps and release the pump from them. It is necessary to remove everything that holds it in the car: bolts, clamps, fasteners. When done, remove the pump and proceed with cleaning.

The design of the pump consists of two parts: the so-called snail and the pump itself with an impeller. In order to clean it, the structure will need to be disassembled, but this is not difficult at all: unscrew a few screws that connect the parts. Now you can carefully examine the impeller. Usually, therein lies the problem: all the garbage wraps around it and prevents the pump from functioning normally during operation. Remove litter from it, collect the pump and put it in place.

Set the machine to its original position, connect it to all communications and start washing, so that later you can see how the water drains. If all is well, then you did it. If the problem persists, then the pump must be changed: it is out of order. Here are some simple rules to avoid premature pump breakdown.

Use special detergents for washing machines.
Do not wash clothes on which there are a lot of decorative elements in inappropriate machines.
Periodically clean.

That's all! In fact, it's not so difficult to maintain the state of your home assistant, you just need to do this regularly, otherwise worse problems will appear!